By: Danny Lipford

Winter will be here soon., and that means bundling up to try to keep warm. You might not realize it, but the pipes on your house need protection from the cold as well if the mercury drops down into the 20s F.

Here are some tips on how to prevent your pipes from freezing and some tips on how to thaw them out safely if they do.

keeping pipes from freezing Bend ORHow to Prevent Pipes from Freezing

  • Insulate Pipes: Insulate hot and cold water pipes in the crawlspace under your house as well as in the basement, attic, and exterior walls (if accessible) with snap-on foam insulation. Make sure foam insulation fits tightly without gaps. Apply duct tape to joints in insulation, and miter foam around elbows, so joints in pipes are completely covered.
  • Heat Pipes: Consider wrapping problem pipes with UL approved heat tape that has a built-in thermostat to prevent overheating. Follow the instructions that come with heat tape carefully to keep from causing a fire hazard.
  • Sprinkler System: Turn off your sprinkler system, and blow compressed air through the irrigation lines to drain the water.
  • Drip Faucets: Drip both hot and cold water at faucets in kitchen and bathroom. This not only keeps water moving through the pipes, but relieves built-up water pressure in the pipes if they should freeze. Set single lever faucets in the center so both hot and cold lines drip. Pay particular attention to pipes running in outside walls.
  • Laundry Room: If there isn’t a faucet in the laundry room to drip, set your washing machine on warm, and start the fill cycle periodically for a few minutes to run water through the pipes.
  • Icemaker: Set your icemaker to make ice if the icemaker water line runs under house.
  • Cabinets: Open cabinet doors under sinks in the kitchen and bath if the cabinets are located on exterior walls, to allow inside heat to pipes.
  • Garage: Keep garage door closed during extreme cold weather.

Read more at TodaysHomeowner.com